 |
|||
|
|
|||
| ||||||||||
|
|  I
MIL-T-48621A (AR)
TABLE III.
Test equipment list (continued).
ITEM NUMBER
DESCRIPTION
40
Power Cable Connector
MS3106A16-1OS
Adapter
41
Cable W201
Drawing:
11822753
I
42.
Cable w202
11822753
Drawing:
43.
cable
Drawing :
11822753
W203
44
Cable W204
Drawing :
118227S2
45.
Speaker LS305
MIL-L-19011/l
46.
Amplifier, Realistic
Specifications:
MPA- 35
Input impedance: 50 K Ohms
Output power: 35 watts (8 ohm 5 %
THD, 20 to 7 KHz)
Input sensitivity (for 35 watt rated
power): 150 mV
Frequency response: 150 Hz - 12 KHz
(-3 DB down)
Signal /noise ratio: 65 DB.
Signal/hum ratio: 65 DB.
Hum & noise level: 5 mV.
Distortion: 1.5% (A X input, 2
watts output Into 8 ohm
outputs : High : 70 volt line
4.7 Methods of Inspection.
4.7.1 Environmental. Environmental tests shall be conducted
- In accordance with the test conditions, general test performance
guidance, and individual test methods of MIL-STD-810, except as
specified herein. Test facilities, chambers and apparatus used in
conducting the tests contained in this specification shall be
capable of meeting the conditions required.
4.7.1.1 Vibration. The test shall be performed as specified
in Method 514, Category 1, Procedure I, of MIL-STD-81O as modified
by 3.3.7 herein. In Step 1 of Procedure I only steps 4 through 8 of
paragraph II-2. I apply. The noise tester shall be attached to the
vibration generator directly or with a fixture, and securely held by
its normal means of attachment. After vibration, the noise tester
shall be tested as specified in 4.7.2 and 4.7.3 herein to determine
compliance with 3.3.7.
24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals