 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-50382(MU)
and latch, head cover and latch, azimuth knob folding handle, elbow detent
lock pin and spring action of the electrical contact shall be operable.
3.10 Illumination.
3.10.1 Reticle. - This requirement shall be met with the line of
sight parallel flat mounting surface within 10 mils. The reticle
markings shall be visible in ambient light conditions ranging from dusk
into night. When required, the use of a mask with a 1/2" aperture,
centrally located on the entrance window, will be permitt to meet this
requirement.
3.10.2 Counters. - The counter numerals shall be visible through all
ambient light conditions.
3.11 Counter numerals. - With the lowest digit of each counter in
coincidence with its respective index line, the remaining numbers shall
be in horizontal alignment within 1/16".
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. - Unless otherwise specified in the
contract of purchyase order, the supplier is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified, the supplier may utilize his own facilities or any other
facilities suitable for the performance of the inspection requirements
specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the Quality Assurance provisions
of this specification. Definitions of inspection terms shall be as listed
in MIL-STD-109.
4.2 First article (initial Production) approval. - The requirement
for first article approval and the responsibility (Government or contractor)
for first article testing shall be as specified in the contract. The
sample for first article approval tests shall consist of three (3) tele-
scopes plus three (3) each of all items covered by SQAP. The sample shall
be manufactured in the same reamer, using the same materials, equipment,
processes, and procedures as used in regular production. All parts and
materials, including packaging and packing, shall be obtained from the
same source of supply as used in regular production.
4.2.1 Government testing. - When the Government is responsible for
conducting first article approval tests, the contractor, prior to sub-
mitting the sample to the Government, shall inspect the sample to insure
that it conforms to all the requirements of the contract and submit a
record of this inspection with the sample, including certificates of
conformance for materials.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals