 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-52843C
the surfaces are free from all foreign matter that would interfere
with the adherence or function of the varnish.
3.30.1 Composition. Composition II shall be used only in the case
when local air pollution regulations governing the application of
varnish precludes the use of composition I. When composition II is
used, the contractor shall provide evidence to the Government that
the use of composition II is required, and shall certify that the
composition II material complies with Rule 442, South Coast Air
Quality Management District.
3.31 Slinging and tiedown provisions. Permanently affixed slinging
and tiedown provisions that enable the forklift to be lifted in its
normal travel position and to be fastened to the floor or deck of a
transportation medium shall be provided. Provisions shall conform to
MIL-STD-209, classes 1 and 2 or class 3 for type II or III equipment,
including air transport requirements.
3.32 Identification marking. Each individual forklift and each
separable attachment removable for either surface or air
transportable purposes (e.g., cab, ROPS, fork carriage or
counterweights) except forks shall be identified in accordance with
MIL-STD-130 on identification plates conforming to MIL-P-514, type 1,
style 1, composition C (GG-P-455, type I, grade A, class 1) material.
The forklift shall also be labeled, on or near data plate, "CARC
month/year" specifying the month and year the forklift was treated.
Additional or specific information to be indented or embossed on the
plate(s) shall be as specified (see 6.2). Plates shall be furnished
and mounted by the contractor. A shipping data plate shall be
furnished and shall conform to MIL-P-514, type III, composition C
(GG-P-455, type I, grade A, class 1) material and, in addition, shall
indicate the silhouette of the forklift in transport position
indicating the center of gravity, the location and capacity of the
lifting and the tiedown provisions. The plates shall be attached by
screws, drive screws, bolts, or rivets in conspicuous protected
locations.
3.32.1 Instruction plates. The forklift shall be equipped with
instruction plates conforming to MIL-P-514, type III, composition C
(GG-P-455, type I, grade A, class 1) material, or commercially proven
decals, including warnings, cautions and diagrams describing any
special or important procedures to be followed in assembling,
operating or servicing the forklift. Commercially unproven labels
shall conform to MIL-STD-1472 (labels).
3.33 Treatment and painting. The portions of the forklift normally
painted, both internally and externally, shall be cleaned, treated,
and painted in accordance with MIL-T-704, type F for ferrous metals
and type G for nonferrous metals and fiberglass top coat camouflage
green 383. Primer in accordance with MIL-P-53030 may be used in lieu
of MIL-P-52192. Finish coat in accordance with MIL-C-53039
39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals