 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-52932D
are deemed necessary to ensure supplies and services conform to prescribed
requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements
of sections 3 and 5. The inspection set forth in this specification shall
become a part of the contractor's overall inspection system or quality
program. The absence of any inspection requirements in the specification
shall not relieve the contractor of the responsibility of ensuring that all
products or supplies submitted to the Government for acceptance comply with
all requirements of the contract. Sampling inspection, as part of
manufacturing operations, is an acceptable practice to ascertain conformance
to requirements, however, this does not authorize submission of known
defective material, either indicated or actual, nor does it commit the
Government to acceptance of defective material.
4.2 Classification of inspections.
The inspection requirements specified
herein are classified as follows:
First article inspection (see 4.4).
b.
Quality conformance inspection (see 4.6).
c.
Inspection comparison (see 4.9).
d.
Inspection of packaging (see 4.10),
4.3 Imspection conditions. Unless otherwise specified herein, all
examinations and tests shall be performed at the ambient temperature and
climatic conditions existing at the place of examination and test. Only that
maintenance established by the contractor and submitted as the maintenance
schedule (see 4.4) prior to commencement of the tests shall be performed
during the tests.
4.4 First article inspection. Prior to production the manufacturers shall
furnish one or more trucks (see 6.2) produced from production tooling for
first article evaluation and test (see 6.4). The truck and its components
shall be compared with this document, published literature and calculations
and test data to verify compliance with this specification. The truck shall
then be subjected to tests and examination as marked in column 1, table III
and column 1, table IV. When the contractor can provide verifiable data
demonstrating compliance to any or all parts of the specified inspection and
testing, these inspections and tests may be waived by the Government. Prior
to examination and tests, the following shall be performed.
a.
Service the truck with the oils, greases, and fuel specified herein
and designated for use in the ambient temperature at which the test
will be conducted. When a diesel engine is furnished, diesel fuel
shall `be used during all testing of the first-produced trucks.
b.
Conduct production run-in as specified in 4.8.
c.
Set the hydraulic system relief pressure as specified by manufacturer
and record. Any change made to this shall constitute failure of all
tests .
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals