 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62246B(AT)
technical data. Technical data shall be limited to specifications and technical material, identical
to that furnished to the authorized company representatives for selection of vehicle models and
components, and shall be available to the engineering offices of' the procuring activity, prior to
delivery of the items. The chassis model furnished shall be not older than the chassis
manufacturer's current model on the date of the invitation for bids.
3.1.1 Special requirements. In addition to the standard vehicle and components specified in
3.1, the vehicle shall be furnished with special equipment as specified herein.
* 3.1.1.1 Painting and marking. Treatment, painting, marking and data plates shall be in
accordance with MIL-STD-1223. The exterior color and the identification markings shall be in
accordance with the requirements of MIL-STD-1223 for the military service identified by the
procuring activity (see 6.2). When specified (see 6.2), concealed markings shall be furnished.
* 3.1.1.2 Rustproofing. When specified (see 6.2), the vehicle shall be rustproofed in
accordance with FED-STD-297. When specified (see 6.2), tropical rustproofing in accordance
with FED-STD-297 shall be furnished.
3.1.1.3 Towing devices. Not less than two hooks, loops or pins, for towing the vehicle, shall
be furnished on the front of the vehicle.
* 3.1.1.4 Wheel splash and stone throw protection. The vehicle shall have rigid splash shields
ahead of the rear wheels and rubber mud flaps to the rear of the rear wheels. All tilt cabs shall
have rubber mud flaps to the rear of the front wheels. A metal strip not less than 1/8 inch thick
and not less than one inch wide, extending the entire width of the mud flap, shall be installed to
prevent the bolt heads or bolt nuts from damaging the mud flap. All splash shield and mud flap
installations, front and rear, shall conform to the rear wheel splash and stone throw protection
provisions of SAE J682.
* 3.1.1.5 Trailer towing package. A trailer towing package consisting of a pintle, safety chain
attachment devices, a lighting receptacle, and associated reinforcements and wiring shall be
installed on the rear of the vehicle. The pintle shall be of the rotating type conforming to
MS51335-1. The pintle shall be installed on the chassis frame with reinforcements to transfer a
vertical tongue load of not less than 1,800 pounds and a horizontal drawbar load of not less than
18,000 pounds directly to the chassis rails. The rearmost portion of the pintle shall be forward,
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals