 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62246B(AT)
* 3.6 Servicing and adjusting. Prior to acceptance of the vehicle by the Government inspector,
the contractor shall service and adjust each vehicle and its mounted equipment for operational
use including at least the following: alinement of lights; adjustment of the engine, electrical and
brake systems; filling and charging of the battery; alinement of the front wheels; inflation of all
tires; complete lubrication of the chassis, engine, and running gear, with grades of lubricants
recommended for the ambient air temperature at the delivery point; servicing of the cooling
system with a solution of ethylene glycol type antifreeze and water in equal parts by volume; and
servicing of the windshield washer reservoir with water and appropriate additives.
3.7 Workmanship. Defective components or parts and assemblies which have been repaired
or modified to overcome deficiencies shall not be furnished. Welded, bolted, and riveted
construction utilized shall be in accordance with the highest standards of the industry.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the supplier is
responsible for the performance of all inspection requirements as specified herein. Except as
otherwise specified in the contract, the contractor may use his own or any other facilities suitable
for the performance of the inspection requirements specified herein, unless disapproved by the
Government. The Government reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
* 4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3
and 5. The inspection set forth in this specification shall become a part of the contractor's
overall inspection system or quality program. The absence of any inspection requirement in the
specification shall not relieve the contractor of the responsibility for assuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to acceptance of
defective material.
4.2 Government verification. Quality assurance operations performed by the contractor will
be subject to Government verification at unscheduled intervals. Verification will consist of
observation of the operations to determine that practices, methods, and procedures of the
contractor's inspection are being properly applied. Failure of the contractor to promptly correct
product deficiencies discovered shall be cause for suspension of acceptance until correction has
been made or until conformance of product to specification criteria has been demonstrated.
23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals