 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62316B(AT)
*
3.4.5 Automatic transmission. An automatic transmission shall be furnished.
3.4.6 Driveline components. The drive line components shall be adequate to transmit the
maximum delivered torque of the engine, as developed through the maximum gear train
reduction.
3.4.7 Suspension. The vehicle shall be equipped with suspension system with components
having a rated capacity at least equal to the load imposed on each member, measured at the
ground, with the vehicle loaded to specified payload. When suspension is rated at the spring
pads, unsprung weight shall be deducted. The vehicle shall be equipped with hydraulic,
double-acting shock absorber at each wheel. Heavy duty springs, front and rear, shall be
furnished. Suspension stabilizer devices shall be furnished. Heavy duty is defined as having a
rated capacity equal to the load imposed, plus at least 5 percent, with vehicle loaded with
specified payload.
3.4.8 Axles. Axle ratings shall be at least equal to the load imposed on each axle, measured
at the ground, with the vehicle loaded to specified payload. The front axle and its steering
components shall be the manufacturer's rated heavy duty type.
* 3.4.9 Wheels, rims, tires end tubes. The vehicle shall be equipped with single front and rear
wheels. Rims and tire ratings shall conform to Tire and Rim Association or European Tyre and
Rim Technical Organisation recommendations for the type and size of tires furnished. Except
when tube type tires are specified in the procurement documents, multi-piece rims shall not be
furnished. Tire size, tire load range (ply rating) shall be the same for all tires on the vehicle.
When specified (see 6.2), disc type wheels shall be furnished.
* 3.4.9.1 Tires. Unless otherwise specified (see 6.2), tires shall be of the tubeless type with
highway tread. Unless otherwise specified, low profile or standard profile tires may be
furnished. Tires shall be of the steel belted radial type or when specified (see 6.2), bias ply.
Tires shall be of rated capacity at least equal to the load imposed on each tire, measured at each
wheel, at the ground, with the vehicle loaded to specified GVW. Tubes and tires shall conform
to Tire and Rim Association or to the European Tyre and Rim Technical Organisation
recommendations.
* 3.4.9.2 Inner tubes. When tube tires are specified in procurement documents, inner tubes
shall be of proper size for tires furnished. Tube type radial tires shall have radial tire inner tubes.
3.4.9.3 Spare tire assembly. A spare wheel or rim shall be mounted on a carrier and
installed in an accessible location on the inside (streetside) rearward of the meter plug-in cabinet
(see figure 5). The carrier design shall enable safe removal or mounting of spare wheel assembly
using only tools specified in 3.4.14.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals