Click here to make tpub.com your Home Page

Page Title: Windshield wipers and washers
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-62319C
inside the cab through mechanical linkage, with both front doors equipped with external
key-operated locks. Cab doors shall have windows with crank-operated window regulators. A
rear window shall be provided. Interior lighting shall be provided. The cab roof shall be of one
piece-construction or, if welded, the roof shall give the appearance of one piece, with weld seams
being continuous, waterproof, and free of visible seams, bumps or protrusions. Full length drip
moldings shall be mounted above the doors. When a crew cab is furnished, the cab-to-axle
dimension shall be measured from the back face of the crew cab.
3.4.12.2.1 Crew cab seat spacing. With the front seat adjusted to the extreme forward
position there shall be not less than 30 inches, measured in a horizontal plane, between the front
of the rear seat-back and the rear of the front seat-back. A kick-space height of not less than
2-3/4 inches shall be maintained between the floor and the rear of the front seat in all positions of
adjustment. Leg room and space forward of the front seat shall be equivalent to that provided
ahead of the seat in a two-door standard cab.
3.4.13 Steering. Power steering shall be furnished.
3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual windshield
wipers and windshield washers. Windshield wipers shall be of the multispeed type and operated
by either air or electric motor(s).
3.4.15 Bumper. Unless the bumper is an integral part of the vehicle cab, a channel type front
bumper shall be provided.
3.4.15.1 Rear end protection. The rear end of the vehicle shall be protected in accordance
with Federal Motor Carrier Safety Regulation 393.86.
3.4.16 Tool stowage. Stowage space of sufficient size to accommodate a vehicle jack, hand
tools, antiskid chains, and emergency reflective triangles shall be furnished for retaining
equipment during vehicle operation. Stowage space for tools may be furnished inside the cab.
When stowage space for tools is located outside the cab, it shall be weatherproof and shall
provide for locking with a padlock.
3.4.16.1 Tools. When specified (see 6.2), each vehicle shall be furnished with the tools
required for exchanging a mounted tire assembly with the spare assembly, and shall include at
least a hydraulic jack, jack handle and wheelnut wrench. The jack shall be of such closed height
as to permit its location under the axle, or other satisfactory lift point, at any wheel with the tire
flat. The jack, without blocking, shall be capable of raising any wheel of the loaded vehicle to a
height adequate to permit removal and replacement of the wheel and tire assembly.
21

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business