4.4 Special sampling for environmental testing.
4.4.1 Samples shall be selected from lots at random using
inspection Level S-3 Table I of MIL-STD-105. Acceptance or
rejection of the lot shall be in accordance with AQL 2.5 of
Table II-A of MIL-STD-105. The samples shall have met all the
requirements and tests outlined in Table I prior to being
subjected to the following examination and test.
4.4.2 Failure of sample. - Should any one item of a special
sampling fail to meet the specified test requirements, accept-
ante of the represented inspection lot will be suspended by the
Government until necessary corrections have been made by the
contractor and the resubmitted samples have been approved (see
4.5 Inspection equipment. - Requirements for inspection
equipment to perform examinations and tests are specified herein
and in specific contract clauses as applicable. See Section 6
of this specification for general provisions applicable to
4.5.1 Government furnished inspection equipment. - Where
the contract provided for Government furnished test equipment,
supply and maintenance of test equipment shall be in accordance
with the applicable requirements specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
18.104.22.168 Governmant design. - Unless otherwise specified in
the contract, all inspection equipment specified by drawing
number in specification or SQAP forming a part of the contract
shall be supplied by the contractor in accordance with technical
data listed in the List of Inspection Documents when provided
with the Technical Data Package (TDP).