Click here to make tpub.com your Home Page

Page Title: Recurring major defects
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-740G
If the computed process average exceeds the specified AQL, 100 percent inspection shall be
performed and continued until such time that process average for twenty consecutive vehicles is
less than the specified AQL.
6.5 Definitions.
6.5.1 Recurring major defects. A major defect is recurring when the same defect occurs
more than once in the same sample, or when the defect occurs in two successive samples. A
major defect may be considered recurring when the historical inspection records ("P" chart or
equivalent) reflect such a condition. Recurring major defects shall be cause for the entire lot or
lots to be inspected for the recurring defects.
6.5.2 Recurring minor defects. A minor defect is recurring if it occurs more than twice in
the same sample or when the defect occurs in four successive samples. Recurring minor defects
shall be cause for the entire lot or lots to be inspected for the recurring defects.
6.5.3 Leaks. The following definitions shall be used for the examination of defects for
leaks:
a. Weep:
- Any evidence of fluid beyond the seal.
b. Seep:
- Any evidence of fluid beyond the seal that does not result
in formation of a droplet.
c. Droplet:
- Any evidence of fluid beyond the seal that results in the
formation of a droplet.
d. Drip:
- Any evidence of fluid beyond the seal where droplet
forms and falls.
6.6 Corps of Engineers. Drawings D8916-1 through D8916-7 are Corps of Engineers
drawings depicting the bolster body construction. Drawings D8902-1 through D8902-38 are
Corps of Engineers drawings depicting the stake body construction. The above are primarily
engineering design drawings and are not intended for use as shop drawings. Critical dimensions
and tolerance are furnished; however, the contractor is responsible for preparing his own
manufacturing drawings. When tolerances are not shown or where those prescribed could
cumulatively result in improper fits, the contractor is responsible for providing tolerances in
accordance with DoD-STD-100 for the various machining operations to insure proper fit,
assembly and operation of the bolster body. No deviation from dimensions shown on the
engineering design drawings is permissible without prior approval of the contracting officer. All
parts, subassemblies and assemblies requiring identification shall be identified in accordance
with MIL-STD-130.
6.7 Lubricants and oils. Unless otherwise specifically directed by the contracting officer, the
power steering should be serviced with oil conforming to grade 10 of MIL-L-2104.
42

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business