Click here to make tpub.com your Home Page

Page Title: Fluids
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




MILT81821
relief valves, filters, and similar items) to supply regulated pneumatic or hydraulic pressure shall be
built into the power units. A means of depressurization of the pressure lines shall be incorporated in
each unit to relieve line pressure prior to detachment of the power unit from the facility
distribution system or trainer panel.
Any simulated fluids to be used in fluid system trainers shall have
3.2.1.13 Fluids.
characteristics (such as dielectric constant, specific gravity, etc. ) similar to those of the related end
item fluid represented, except for the following: its flash point shall be at least two hundred degrees
(200) F, and it shall not give off toxic fumes which would create a personnel safety hazard. The
simulated fluid shall be free of materials which support bacterial growth or have a corrosive or
deteriorative effect on the materials used in construction of the trainer. Coloring may be added to
the simulated fluid if desired. The fluid system trainers shall be designed and constructed to
withstand the weight of the simulated fluid.
3.2.2 Physical characteristics
The construction of the trainers and affiliated items shall be based
3.2.2.1 Construction.
upon all of the requirements of this document as reflected in the Government approved Detail
Specification. The construction shall optimize performance, physical characteristics, life phases such
as operation, transportation, storage, cost, procurement time and other applicable features.
The actual operating and transporting
dimensions and moments.
3.2.2.2 Weights,
dimensions and weight of each trainer panel shall be listed in the appropriate trainer description in
the Detail Specification. Dimensions and weight shall be held to a minimum consistent with cost ,
available space and training effectiveness. The maximum transporting dimensions of any trainer
panel shall be seventy-two (72) inches in height, sixty (60) inches in width, and one hundred
forty-four (144) inches in length. The weight of each trainer panel in the transporting and operating
configuration shall not exceed three thousand (3,000) pounds. Dimensions and weights in excess of
these limitations will be acceptable only when specifically authorized by the Procuring Activity, and
reflected in the Detail Specification as an authorized deviation to this requirement.
If the size or weight, or both, of actual
3.2.2.2.1 Reduction of component size and weight.
related end item components used in the trainers preclude compliance with the size-weight
limitations specified herein, and deviations are not acceptable to the Procuring Activity, both the
size and weight of these components may be reduced by removing those sections or portions which
contribute the least significant training value. For example, to reduce the length of a landing-gear
17

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business