 |
|||
|
|
|||
| ||||||||||
|
| MILT81821
operations. Cutting-plane surfaces resulting from the sectionalization process shall be primed and
lacquered red, film designation BG in accordance with MILSTD808. If desired, additional colors
may be used for contrast, to differentiate between sectionalized surfaces where they mate together,
or for coloring the interior of certain cutaways to differentiate between pressures, etc.
When coatings are required for animated parts, such coatings
3.3.1.6.5 Animated parts.
shall be lacquer. The colors selected shall provide maximum contrast between the lines and the
background and shall cause minimum light reflection.
All lines applied to the vertical panels of animated
3.3.1.6.6 Animated trainer tines.
trainers shall be covered with lacquer, shall provide maximum contrast between the lines and the
background, and shall cause minimum light reflection.
3.3.1.6.7 Cleaning of lacquered surfaces.
All lacquered surfaces of the trainers shall be
capable of withstanding frequent washing with mild soap and water. The trainer MOM I shall specify
the recommended cleaning agents.
Trainer peculiar metal parts shall be of a corrosionresistant material or
3.3.1.7 Metal.
suitably treated to resist corrosion. The type of metal to be used for trainer peculiar metal parts
shall be indicated in the appropriate trainer descriptions in the Detail Specification, by specifying to
the appropriate general categories of metal to be used (i.e., copper, steel, aluminum, etc.).
Identification of specific type of metal for each trainer peculiar part is not required in the Detail
Specification.
Dissimilar metals, as defined in MlLSTD889, shall be
3.3.1.7.1 Dissimilar metals.
suitably protected against electrolytic corrosion when used in intimate contact with each other.
Unless otherwise specified in the Detail
3.3.1.8 Component requirements, general.
Specification, actual related end item components, plugs, connectors, parts, and equipment shall be
used in the trainer panels.
3.3.1.9 Standard parts.
Common military standard parts shall be used wherever they are
suitable for the purpose and shall be identified by their part numbers. Commercial utility hardware
parts such as screws, bolts, and nuts may be used, provided they have suitable properties and are
replaceable by AN or MlL Standard parts without alterations, and provided the corresponding AN
or MlL part numbers are referenced in the drawings and associated lists. In applications for which
24
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals