 |
|||
|
Page Title:
Cuts way and plasticized parts, general |
|
||
| ||||||||||
|
|  MILT-81821
sufficient detail to permit service personnel to perform an equivalent modification on a standard
related end item replacement part. All related end item, and M I L Standard parts which have been
modified for trainer use shall appear in the parts lists under the standard part number; however, in
each case the part number shall be preceded by an asterisk to indicate that it has been modified for
trainer use. Such altered components shall be marked in accordance with 3.3.3.10.
3.3.1.16 Cuts way and plasticized parts, general. "Where practicable, and when a significant
increase in instructional value can be realized, components of a system, both Contractor and
Government furnished equipment, unless of common design, may be exposed to reveal the internal
mechanism. This shall be accomplished either by cutting away or plasticizing the item to be
displayed. Cutaways are preferred. It is desirable to have such parts remain operable within a
system, but when not practicable, duplicate parts or components that have been cutaway or
plasticized shall be provided. A/Vs shall be provided to illustrate the internal construction and
operation of components which do not lend themselves as cutaways or plasticized parts, or where
the cost of using the actual component is prohibitive. Electrical components whose internal
arrangement cannot be shown by other means shall have clear plastic covers or windows, or be
completely plasticized when a benefit to training can be derived. Plastic covers shall be provided
with fasteners for removal. All cutaway or plasticized parts installed on, or provided with, the
trainer panels shall be listed in the applicable trainer descriptions in the Detail Specification.
Unless otherwise specified in the Detail
3.3.1.16.1 Provision of cutaway components.
Specification, all cutaway components provided with or installed on the trainer panels specified
herein will be cutaway by the Government. The Contractor Furnished Equipment (CFE) and
Government Furnished Equipment (G FE) components shall be provided to the designated
Government Activity for cutaway as soon as practicable, but not later than one hundred twenty
(120) days prior to the scheduled trainer fabrication completion date. Assembly drawings only of
the CFE components to be cutaway shall be provided and shipped concurrently with the
components. The cutaway components will be returned to the Contractor within ninety (90) days
after receipt by the designated Government Activity.
Cutaway and plasticized parts which
3.3.1.16.2 Mounting of cutaway and plasticized parts.
are to be used for individual student instruction shall be securely attached to the trainer panel by
means of quick disconnect mounts. Nonferrous metal mounting plates shall be permanently
installed to prevent damage to the panel surface during removal and replacement of such items.
When it is impractical to mount cutaway and plasticized components on the applicable trainer, a
reusable shipping container shall be provided.
26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals