 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-85031B(AS)
AC power single phase, 115 11.5 v,
a. Console
60 Hz, 3,400 VA.
AC power, three phase (Wye), 115/200
11.5 v, 400 40 Hz, 700 VA, (phase
rotation A-B-C).
AC power, three phase (Wye), 115/200 V,
b.
Test Stand
60 Hz, 24,000 VA, (phase rotation
A-B-C).
3.4.3.1 Primary overload protection. The test set shall be capable of
required performance when protected against electrical overload as follows:
a. The primary power input shall be fused or equipped with
magnetically operated instantaneous-trip circuit breakers.
b.
Electric motors of 10 or more horsepower rating shall be equipped
with heater overload protective devices.
3.5 Performance. The performance of the test set shall be as specified
in 3.5.1 through 3.5.4.1 plus any and all performance requirements specified
in DL 130AS200. Unless otherwise specified herein, these requirements shall
apply under standard service conditions. When reduced performance
requirements for service conditions are acceptable, such variations are
specified herein.
3.5.1 Test Set, Guided Weapon AN/DSM-96B. The Test Set, Guided Weapon
AN/DSM-96B, shall be manufactured in accordance with DL 130AS200, and shall
meet all of the requirements stated therein and in 3.6.1.1. Figure 1 shows
the test set.
The general functions of the
3.5.1.1 Test set functions (descriptive).
test set shall be as follows:
a.
Provides inputs (mechanical, electrical, and optical) to the weapon
under test (see table I).
b.
Verifies the flight-ready condition (GO or NO-GO) of each assembled
weapon (less wings and fins) under test thereon, for weapons listed
in table I. (Fuze is not electrically checked. )
c.
Electrically isolates any control or guidance section of weapons
listed (see table I) which exhibits a NO-GO indication for azimuth
and elevation guidance signals, but not for azimuth and elevation
gimbal angle signals. The optional gravity trim test will isolate
between guidance section or control section failures.
d.
Rechecks the flight readiness of the reassembled weapon under test
when the guidance section or control section has been replaced.
3.5.2 Test Console, Guided Weapon OJ-115B/DSM-96. The Test Console, Guided
Weapon OJ-115B/OSM-96, hereinafter referred to as the test set consolel,
shall be manufactured in accordance with DL 130AS200, and shall meet all of
the requirements stated therein and in 3.5.2.1.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals