 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-9720F(USAF)
4.6.18 Drift test. This test shall demonstrate that, with the engine
operating at 1800 rpm and a 3000 pound load on the table, the hydraulic actu-
Lift arm drift shall be meas-
ator drift does not exceed 1/2 inch per hour.
T i l t , longitudinal and lateral cylinder drift
ured at the front of the cradle.
shall be measured relative to the respective cylinder rod,
4.7
Q u a l i t y program.
4 . 7 . 1 I n s p e c t i o n s y s t e m . Unless otherwise specified in the contract or
purchase order, the contractor shall implement and maintain an inspection sys-
tem in accordance with MIL-T-45208.
4 . 7 . 1 Sampling p l a n .
Sampling plans shall be in accordance with
MIL-STD-l05.
4 , 7 . 3 L e v e l o f i n s p e c t i o n . Unless otherwise specified in the contract or
purchase order, the inspection level shall be level II with an AQL of 1.5.
PACKAGING
5.
5 . 1 L e v e l s o f preservation
and packaging.
5.1.1 Level A.
The lift truck shall be preserved and packaged in accord-
ance with MIL-STD-162.
The life truck shall be preserved and packaged in accord-
5.1.2
L e v e l C.
The lift truck shall be pre-
ante with
manufacturer's commercial practice.
pared for
shipment in such a manner as to assure adequate protection against
corrosion
and deterioration during shipment to the using, activity for immediate
use
Levels of p a c k i n g
5.2
5.2.1 Level A.
The lift truck shall be crated to conform to MIL-C-104,
style B, sillbase crating.
5.2.2 Level B.
T h e l i f t t r u c k , preserved and packaged in accordance with
5.1.1, shall he prepared for shipment as a mobile load.
5.2.3 Level C.
The lift truck shall be prepared for shipment in such a
manner as to insure safe transportation at the lowest rate to the point of
delivery.
The lift truck, so prepared, shall meet uniform classification rules
or regulations of other carriers as applicable to the mode of transportation.
5 . 3 M a r k i n g . In addition
to any special marking specified by the contract
or purchase order, the crates
shall be marked in accordance with MIL-STD-129.
The nomenclature shall be as
follows.
Truck Lift Aerial Stores, 3000 pounds
c a p a c i t y , M J - 1 A or MJ-lB, a s
applicable.
6.1 Intended use
The lift truck covered by this specification is Intended
for use in or around hardstands and landing strips, to pick up, t r a n s p o r t ,
p o s i t i o n and load aerial stores into aircraft
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals