 |
|||
|
|
|||
| ||||||||||
|
|  MIL-V-3083D
3.12 Safety. All exposed edges shall be rounded or beveled. All exposed high temperature
surfaces shall be guarded to prevent inadvertent contact by operating personnel.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase
order, the contractor is responsible for the performance of all inspection requirements as specified
herein. Except as otherwise specified in the contract or order, the contractor may use his own or
any other facilities suitable for the performance of the inspection requirements specified herein,
unless disapproved by the Government. The Government reserves the right to perform any of the
inspections set forth in the specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3 and 5.
The inspection set forth in this specification shall become a part of the contractor's overall
inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of assuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to acceptance of defective
material.
4.1.2 Component and material inspection. The contractor is responsible for ensuring that
components and materials used are manufactured, examined and tested in accordance with
referenced specifications and standards as applicable.
4.2 Classification of inspections. Inspection requirements specified herein are classified as
follows:
a. First article inspection (see 4.3).
b. Quality conformance inspection (see 4.4).
c. Inspection of packaging (see 4.6).
4.3 First article inspection.
4.3.1 Examination. The vibrator shall be examined as specified in 4.5.1. Presence of one or
more defects shall be cause for rejection.
4.3.2 Tests. The vibrator shall be tested as specified in 4.5.2 through 4.5.2.9. Failure of any
test shall be cause for rejection.
4.4 Quality conformance inspection.
4.4.1 Sampling. Sampling of accessories for examination shall be in accordance with MIL-
STD-105.
4.4.2 Examination. Samples selected as specified in 4.4.1 shall be examined for the defects
specified in 4.5.1, as applicable.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals