Click here to make tpub.com your Home Page

Page Title: Functional testing cont'd
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




MIL-W-43001F
(a) The extraction of water from saturated sheets for compliance with
3.5.  For this test, sheets shall be placed in a laundry drying tumbler air
heated to 190F ; 5F and tumbled for not less than 15 minutes to establish
normal dry weight.  The sheets, immediately after being tumbled and weighed,
shall be placed in the washer-extractor being tested to the amount of its
minimum capacity as specified.  The sheets in the machine being tested shall be
run through the operations using Formula A (see 3.5 and 4.6.2.1), extracted for
not more than 12 minutes, removed from the machine, and weighed to determine
compliance with the extraction requirements specified in 3.5.  The machine shall
meet the functional requirements for washing woolen blankets using Formula F
(see 4.6.2.1).
(b) water or soap solution shall not back up or overflow through supply
containers or vent pipe during extract cycles (see 3.5).
(c) Anti-vibration mount components failure (see 3.5).
(d) No leaks during washing and extracting cycles (see 3.5).
(e) Moving parts and bearings shall not overheat (see 3.5).
(f) No structural failures (see 3.5).
(g) LOW speed extraction or intermediate load positioning cycle (as
applicable) is operable (see 3.5 and 3.5.2.8).
(h) Operation of the vibration limiting device, or automatic self-
Balancing where applicable, for compliance with the requirements of 3.5.1.8.
(i) Foundation equipment, except concrete, for compliance with the
requirements of 3.5.1.9 (when applicable).
(J) Seal leakage for compliance with the requirements of 3.5.1.13.
(k) Operation of the steam connection for compliance with the require-
u ents of 3.5.1.16 (steam not in direct contact with the load).
(1) Amplitude of vibration is greater than 0.005 inches displacement for
machines with anti-vibration protection, or is greater than 0.010 inches
displacement for machines without anti-vibration protection (see 3.5.1.21).
(m) Machine does not absorb 90 percent of the dynamic load (see 6.2 and
3.5.1.21).
(n) Shell for compliance with the water-tightness, distortion, and
vibration requirements of 3.5.2.1.
(0) Shell doors on end loading machines for compliance with the latching
requirements of 3.5.2.3.1.
28

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business