 |
|||
|
|
|||
| ||||||||||
|
|  MIL-W-43001F
(t) Whether the successful bidder is to furnish supervision of installa-
tion or demonstration services of the equipment. If required, the
location, approximate date, the person or office to report to, and
any accommodations or services to be supplied by the installation
or agency, will be stated.
6.2.1 Contract data requirements. Any requirements for equipment manuals for
the items covered by this document should be included in DD Form 1423 Contract
Data Requirements List and cited in the contract.
6.3 First article. When a first article is required, it shall be inspected
and approved under the appropriate provisions of FAR 52.209. The first article
should be a preproduction sample. The contacting officer should specify the
appropriate type of first article and the number of units to be furnished. The
contracting officer should include specific instructions in all acquisition
instruments regarding arrangements for selection, inspection, and approval of
the first article.
6.4 Successful commercial operation. Invitation for bids shall specify that
no item of equipment will be acceptable unless the manufacturer has had equip-
ment of approximately the same type, capacity (plus or minus SO pound capacity)
and class as that offered which shall have operated successfully in a commercial
or institutional laundry for at least one year. Equipment installed for test
purposes in a manufacturer's plant or laboratory will not be considered as
complying with this requirement.
6.5 Pass through machine wall partitioning. The partitioning wall may at
the manufacturer's option be separated from the machine by not less than 3
linear inches of a tough, flexible, plasticized material. When the manufacturer
employs the separation method, the material shall be furnished with the machine.
6.6 Mass vibrometer. A Starret 192 vibrometer has been found acceptable as a
test instrument when measuring vibrations.
6.7 Subject term (key word) listing
Laundry
Washer
6.8 Changes from previous issue. The margins of this document have been
marked with an asterisk (*) to indicate where changes (additions, modification,
corrections, deletions) from the previous issue were made. This was done as a
convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to
evaluate the requirements of this document based on the entire content irres-
pective of the marginal notations and relationship to the last previous issue.
32
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals