 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-48409A(MU)
4.1 Responsibility for inspection. - Unless otherwise specified in
the contract or purchase order, the supplier is responsible for the per-
formance of all inspection requirements as specified herein. Except as
otherwise specified, the supplier may utilize his own facilities or any
other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The Govern-
ment reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed. necessary to assure supp-
lies and services conform to prescribed requirements.
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the quality assurance provisions
of this specification. Definitions of inspection terms shall be as listed
in MIL-STD-109.
4.2 First Article (initial production) approval. - The requirement
for first article approval and the responsibility (Government or contractor)
for first reticle testing shall be as specified in the contract. The sam-
ple for first article approval tests shall consist of three assemblies
manufactured in the shine manner, using the same materials, equipment, pro-
cesses, and procedures as used in regular production. All parts and ma-
terials, including packaging and packing, shall be obtained from the same
source of supply as used in regular production. The three first article article
samples will be submitted to all the tests indicated in Table I and Table II.
Of the tests indicated in Table III and Table IV, one sample shall be sub-
jected to the Fungus Test (4.6.2.7) and the other samples shall be subjected
to the other test specified.
4.2.1 Government testing. - When the Government is responsible for
conducting first article approval tests, the contractor prior to submitt-
ing the sample to the Government, shall inspect the sample to insure that
it conforms to all the requirements of the contract and submit a record
of this inspection with the sample, including certificates of conformance
for materials.
4.2.2 Contractor testing. - When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected by
the contractor for all the requirements of the contract. The sample and
a record of this inspection, including certificates of conformance for
materials, shall be submitted to the Government for approval. The Govern-
ment reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of product. - Unless otherwise specified by the con-
tracting officer, inspection lot size, lot formation and presentation of
lots shall be in accordance with "Submission of Product" provisions of
MIL-STD-105.
4.3.2 Examination and tests.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals