 |
|||
|
Page Title:
Other Government documents, drawings, and publications |
|
||
| ||||||||||
|
|  MIL-C-11015E
2.2.2 Other Government documents, drawings, and publications. The following other Government documents,
drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified,
the issues are those cited in the solicitation.
FEDERAL STANDARDS
Handbook H28 - Screw-Thread Standards for Federal Services.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the
Document Automation and Production Service, Building 4D (DPM-DODSSP), 700 Robbins Avenue, Philadelphia, PA
19111-5094.)
2.3 Non-Government publications. The following document(s) form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue
of the DoDISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the DoDISS
are the issues of the documents cited in the solicitation (see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/NCSL Z540-1-1994 - Calibration Laboratories and Measuring and Test Equipment, General
Requirements for.
INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)
ISO 10012-1 - Quality Assurance Requirements for Measuring Equipment,
Part 1: Meteorological Confirmation System for Measuring Equipment.
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein (except for related associated specifications, specification sheets, or MS sheets), the text of this document
takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
3. REQUIREMENTS:
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with the
applicable specification sheets. In the event of any conflict between requirements of this specification and the
specification sheets, the latter shall govern. (see 6.2)
3.2 Qualification. Capacitors furnished under this specification shall be products which are qualified for listing on
the applicable qualified products list at the time set for opening of bids (see 4.4 and 6.3).
3.3 Materials. Materials shall be as specified herein. However, when a definite material is not specified, a
material shall be used which will enable the capacitors to meet the performance requirements of this specification.
Acceptance or approval of any constituent material shall not be construed as a guaranty of the acceptance of the
finished product.
3.3.1 Insulating and impregnating compounds. Insulating and impregnating compounds, including resins,
varnishes, waxes, and the like, shall be suitable for each particular application. Compounds shall preserve the
electrical characteristics of the insulation to which they are applied.
3.4 Design and construction. Capacitors shall be of the design, construction, and physical dimensions specified
(see 3.1).
3.4.1 Threaded parts. All threaded parts (see 3.1) shall be in accordance with Handbook H28.
3.4.2 Solder-type terminals. Solder-type terminals shall be coated with solder having a 40 to 70 percent tin
content.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals