 |
|||
|
Page Title:
Pattern width and launcher alignment test. |
|
||
| ||||||||||
|
|  MIL-D-63303B(AR)
d.
Launcher switch in READY.
Pattern selector switch in JOG-CENTER.
e.
Check wheel speed setting in accordance with the applicable
requirements.
Check wheel speed under load as follows:
selector
switch
a.
Mode
in
DISPENSE.
b.
Density selector switch in MAXIMUM.
c.
Pattern selector switch in JOG-CENTER.
Launch eighty (80) practice mines from each magazine simul-
taneously and-check wheel speed for compliance with applicable
requirement.
4.6.2.13.7 Launch ranqe test. Test launch range as follows:
Mode selector switch in DISPENSE.
a.
b.
Density selector switch MAX.
c.
Pattern selector switch in JOG-CENTER.
Launch ten practice mines from each magazine. The distance
for mines launched, shall be obtained using a tape measure and
observed for compliance with the applicable requirement.
4.6.2.13.8 Pattern width and launcher aliqnment test. Test for
pattern width as follows:
Mode switch in DISPENSE.
a.
b.
Density selector switch in MAX.
Pattern selector in jog mode.
c.
d. Position launcher at the left reversal point of the
pattern 3 travel.
e. With variable speed motor driving dispenser wheel at a
simulated 4 to 6 mph (6.4 to 9.7 kmph), launch twenty-five
(25) practice mines from each magazine.
f. Position launcher at the right reversal point of the
pattern 3 travel.
55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals