Dispenser, Mine, Ground Vehicle: M128

• Dispenser, Mine, Ground Vehicle: M128
• Specifications and standards-cont.
• Other publications.
• Initial production inspection.
• Capability of welder equipment and welder operators.
• Power system and accessories.
• Hydraulic system.
• Voltage generation system (alternator).
• Control panel malfunction warning and automatic shut down system.
• Dispenser and systems assembly and adjustments.
• Table 1. Speeds and Distances for Break-in Run
• Launcher oscillation angle full sweep.
• Automatic shutdown systems.
• Mine dispersion.
• Table 3. Dispersion Configuration
• Table 4. Mine Densities
• Painting, markinq and data Plates.
• Threaded parts or devices.
• Metal fabrication.
• Mounted hardware installation.
• Responsibility for inspection.
• Initial production inspection.
• 500 mile test
• Table 6. 500 Mile Test
• Break-in run.
• Inertia brake actuator test.
• Table 7. Quality conformance inspection
• Dispenser, Mine, Ground Vehicle: M128
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Dispenser, Mine, Ground Vehicle: M128-cont.
• Table 8. Classification and Location or Inspections and Tests
• Table 8. Classification and Location or Inspections and Tests-cont.
• Test conditions.
• Dispenser Acceptance Test Failure.
• Acceptance test failure.
• Hydraulic system tests.
• Relief pressures, inlet pressures and case drain pressures
• Voltage generating system (alternator).
• Test of Engine Temperature Circuits
• Test of Left Tab Circuits
• Test of Control Logic and Hydraulic Circuits
• Test of Left Density Circuits
• Test of Right Density Circuits
• Test of Left Jammed Mine Circuits
• Test of the Self Destruct Time Long Circuit
• Transmitter assembly power supply (TAPS) levels and indicators
• Control panel malfunction warning and automatic shut-down system.
• Dispenser and systems assembly and adjustments.
• Painting, marking and data plates.
• Launcher sweep rate test.
• Pattern width and launcher alignment test.
• Automatic shut-down systems test.
• Comparison tests.
• Density and pattern selections.
• Density and pattern data.
• Thermocouple location.
• Low temperature test conditions.
• Low temperature operation-cont.
• Cold starting and operating.
• Repair parts.
• Preproduction model.
• Definitions of unlisted defects, recurring major and minor defects
• Load, combat load, payload.
• Central position.
• Figure 1. Profile of Test Track (Artificial Bump)
• Blank Page

Dispenser, Mine, Ground Vehicle: M128

Privacy Statement - Press Release - Copyright Information. - Contact Us