 |
|||
|
|
|||
| ||||||||||
|
|  MIL-I-48331A(AR)
3.15 Temperature. The IC shall be capable of operating
over the temperature l imits of minus fifty five degrees
centigrade (-55 C) to plus eighty degrees centigrade
(+80C) first article tests, and minus forty degrees
centigrade (-40C) to plus sixty degrees centigrade
(+60C), lot acceptance tests. See Tables I, III & IV also
paragraph 4.4.2.4 and 4.4.2.5.
3.16 Country of origin. The IC shall be manufactured and
sold by a qualified producer in the United States or in another
country which is a party to one of the existing international
agreements ratified by the United States, such as the NATO
STANAG-4093, Mutual Acceptance of Qualification Approvals for
Electronic Parts, and the United States/Canada/
Australia Agreement for Qualification of Products for Non-
resident Manufacturers.
3.17 Group C environmental requirements. The IC shall
comply with the requirements of paragraph 4.4.2.6 and to the
If more than two (2)
applicable test method of MIL-STD-863
relevant failures result from the first or combined sample, the
I.C. supplier will perform failure analysis to determine cause
and institute corrective action. A copy of the failure
analysis report is to be furnished to the technical agency
listed in paragraph 6.5.
The IC when
3.18 Mechanical shock, ballistic rail gun.
mounted in a electrically functionable ADAM wedge and loaded
into a 155MM test vehicle projectile, shall be capable of
surviving the mechanical shock associated with a zone 7X firing
or equivalent from a 155MM howitzer. In addition, the IC shall
be capable of surviving cargo ejection with subsequent ground
impact in a random orientation of an uncontrolled surface which
may include rocks or other hard matter. The wedge shall be
electrically tested as per MIL-P-48189(AR).
3.19 Data requirements. Data shall be recorded and
retained for all test required by this specification as
specified in 4.5.17.11.
3.20 Process controls. The vendor will manufacture IC
devices in an approved MIL-M-38510 facility and will adhere to
the appropriate MIL-M-38510 documents.
In the event of any
non-conformance, the following should occur.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals