 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-63530 (AR)
4.5.24 Steady state life. Devices shall be subjected to the steady state
life test in accordance with MIL-STD-883, Method 1005, Condition D and as
specified herein, Test duration shall be 1000 hours minimum at 125C
5C. For this test the device shall be connected as shown in Figure 11, the
same test set up as for the burn-in test. Electrical parameters shall be
measured before, during and after the steady state life test in accordance
with Method 1005 and Table II. my device failing to meet the electrical
parameters requirements of Table II shall be classed defective.
(Non-destructive test).
4.5.25 Data requirements. The contractor shall submit a quality
inspection test, demonstration and evaluation report giving all detailed
inspection and test results in accordance with Data Item Description
DI-R-1724, test report format shall be submitted to the technical agency
listed in 6.5.
PREPARATION FOR DELIVERY
5.
5.1 Preservation, packaging and packing. Devices to be delivered under
this specification shall be prepared for delivery in accordance with the
requirements of MIL-M-38510, Level C. Electrostatic discharge (ES) protection
in accordance with the requirements of MIL-M-55565 shall be provided.
Marking shall be in accordance with MIL-STD-1188.
5.2 Marking.
6.1 Intended use. The device covered by this specification is intended
for use in U.S. Army Ordnance.
6.2 Ordering data.
The procurement documents shall specify the following:
(a) Title, number and date of this specification.
(b) Provisions for submission of first article samples.
(c) Quantity required and delivery schedules.
(d) Requirement for certification of conformance for each
lot or shipment of product.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals