 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-81260A(AS)
3.6.5.3
Checkout, - Depot checkout shall parallel the requirements
stipulated for intermediate maintenance (See 3.5. 3.4.1.)
3.6.6.4
Disassembly. - Instructions shall parallel the requirements
stipulated for intermediate maintenance (3. 5.3.4. 3) and shall include instructions
necessary to disassemble to the extent authorized for depot maintenance.
3.6.6.5
Cleaning. - Depot cleaning shall be limited to peculiar clean-
ing requirements and shall parallel the requirements outlined in 3.5.3.4.4.
Inspection. - Instructions shall parallel the requirements of
3.6.6.6
3.5.3.4. 5; however, overhaul limits and standards shall be reflected.
3.6.6.7.
Repair. - Repair instructions shall be provided to cover the
complete repair capability authorized by the procuring activity. Text will be
supplemented with illustrations as necessary to describe complex procedures.
Repair methods shall be specified for the correction of all deficiencies and con-
ditions considered repairable when inspected but shall not cover assemblies re-
placed as units because they cannot be economically repaired or overhauled.
Description of common procedures shall be omitted. Specific data shall be pro-
vided to adequately describe acceptable repairs. When applicable, these instruc-
tions shall supplement the requirement outlined in 3.5.3.4.6.
3.6.6.8
Tolerance and Limits .- Presentation of tolerances and
limits shall be in accordance with 3.5.3.4.7; however, they shall reflect the
requirement of depot level maintenance. This section shall consist of introduc-
tory material, the Table of Limits, a miscellaneous table, and charts showing
the limit points and lubrication system.
3.6.6 .8.1
The introductory material shall include definitions of unusual
terms and abbreviations; also, a statement to the effect that a minimum and max-
imum are set up as ideal limits and that measurements not exceeding the replace-
ment maximum permit the part to be continued in service.
3.6.6 .8.2
The Table of Limits shall be supported by illustrations
(charts) to show clearly all points of limits. Illustrations shall not show limit
values but only index or reference numbers with leaders to the point of clear-
ance. The illustrations shall also show lubrication information. Pressure oil,
return oil, scavenge oil, propellants and pump fluids shall be differentiated by
cross-hatching or other drafting means or by colors, with a lengend explaining
the coding.
3.6.6 .8.3
The miscellaneous table shall include spring pressures and
torque limits.
37
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals