Click here to make tpub.com your Home Page

Page Title: Preservation, packing and marking
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-P-18472G(SH)
5.
PACKAGING
(The packaging requirements specified herein apply only for direct Govern-
ment acquisition.  For the extent of applicability of the packaging requirements
of referenced documents listed in section 2, see 6.7.)
5.1 Preservation, pack ing and marking.  Pump units and accessories shall be
preserved level A or C, and packed level A, B, or C (see 6.3) as specified (see
6.2).
6.
NOTES
(This section contains information of a general or explanatory nature that
may be helpful, but is not mandatory.)
6.1
Intended use.  Pumps covered by this specification are intended for
condensate, boiler feed booster, waste heat boiler, and distilling plant services
on board Naval ships.
6.2  Acquisition requirements.
Acquisition documents must specify the
following:
(a) Title, number, and date of this specification.
(b) Issue of DoDISS to be cited in the solicitation, and if required,
the specific issue of individual documents referenced (see 2.1.1
and 2.2).
(c) When first article is required (see 3.1).
(d) Class required (see 1.2).
(e) General design required (see 3.2).
(1) Space and weight requirements (see 3.2).
(2) List, pitch, roll, trim, and other ship attitude conditions
(see 3.2, 3.2.7, and 4.6.3.3).
(3) Environmental vibration frequencies (see 4.6.3.4).
(4) Airborne, structureborne,  and fluidborne noise requirements
(see 3.2.4 and 4.6.1.4).
(5) Ambient temperature, normal, maximum, and minimum.
(f) Performance-characteristics (see 3.2 and 3.3.2).
(1)
Rated capacity and range of capacity.
(2)
Rated total head at rated capacity.
(3)
Fluid to be pumped.
(4)
Specific gravity of fluid.
Temperature of fluid, normal, maximum and minimum (see
(5)
3.3.2.1.1  and  4.6.1.3).
(6)
Suction head available, normal, maximum, and minimum and flow
control method (see 3.3.2.1.1, 4.6.1.3, 4.6.2.1 and
4.6.3.1.3).
(7)
Casing design and test pressures.
(8)
Special performance requirements, if any (for example,
maximum shutoff head).
35

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business