Whether shock mounts are to be used (see 22.214.171.124).
Vibration test requirements (see 3.2.3, 4.6.3(d), and 126.96.36.199).
Noise test, if required, and noise level limits (see 3.2.5,
4.6.1(d), and 188.8.131.52).
Horizontal or vertical mounting (see 3.2.6).
Bedplates for close-coupled pumps (see 184.108.40.206.2).
Type of pressure regulating governor (see 3.2.11).
Gauge connections (see 3.2.11).
Ordering data for driver (see applicable specification;
MIL-T-17523 for turbines (see 3.2.13); MIL-M-17413 or
MIL-M-17060 for motors (see 3.2.14); whether motors are for
Class of motor insulation (see 220.127.116.11).
Ordering data for electrical controllers, if required (see
MIL-C-2212 and 3.2.15).
Additional requirements for valves, flanges, fittings, and bolting
for pipe connections (see 3.2.18).
Type of driver (see 3.2.22).
Coupling (see 3.3.1).
If suction and discharge connection requirements are other than
specified (see 3.3.4).
Diameter of hatch through which pump must pass (see 18.104.22.168).
If pressure regulating governor is required (see 3.3.12).
If pump is to be shock tested without driver (see 22.214.171.124.7).
Level of presentation, packing, and marking (see 5.1).
Designation of manufacturer (pump or driver) responsible to the
purchaser for compatibility of pump and driver and operation of
the assembled units.
6.3 Con sideration of data requireme nts. The following data requirements
should be considered when this specification is applied on a contract. The
applicable Data Item Descriptions (DIDs) should be reviewed in conjunction with
the specific acquisition to ensure that only essential data are requested/
provided and that the DIDs are tailored to reflect the requirements of the
specific acquisition. To ensure correct contractual application of the data
requirements, a Contract Data Requirements List (DD Form 1423) must be prepared
to obtain the data, except where DoD FAR Supplement 27.475-1 exempts the
requirement for a DD Form 1423.
Sugg ested Tailoring
Level 2 or 3
and associated lists