 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-18547A(SHIPS)
3.10.2.4.1 The format of the list shall include a beading and columns of data for the items listed. The
shall include titles and applicable entries as follows:
Reproduced from drawing number
Number of ships
Application
Contract or order number.
.
Manufacturer
Quantities are for
units per ship
The columns shall include:
Piece number
Name of part
Quantity
Drawing number
Federal Stock Number
Additional columns may be used as applicable
3.10.2.4.2 The list shall be so treated as to be resistant to oil, water and fading.
3.10.3 Stock. - The selection, stock numbering and quantities of repair parts for stock shall be deter-
mined and processed in accordance with MIL-P-15137.
3.10.3.1 Unless otherwise specified in the contract or order, the cognizant inventory control point for
repair parts for stock shall be Ships Parts Control Center, Mechanicsburg, Pennsylvania.
3.10.4 Onboard and stock repair parts for the drivers and accessories shall be in accordance with the
related equipment specifications.
3.10.5 Workmanship. - The equipment, including all parts and accessories, shall be manufactured and
finished with first class workmanship in all respects.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. - Unless otherwise specified in the contract or purchase order. the
supplier is responsible for the performance of all inspection requirements as specified herein. Except as
otherwise specified, the supplier may utilize his own facilities or any commercial laboratory acceptable to
the Government. The Government reserves the right to perform any of the inspections set forth in the speci -
fication; where such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.2 Quality control system (for class O-1 pumps only). - The supplier shall provide and maintain a qual-
ity control system acceptable to the Government for the supplies covered by this specification. The system
of quality control shall be in accordance with MIL-Q-9858 supplemented as specified in 4.2.1 through 4.2.3.1.
4.2.1 Description of procedures. - Procedures shall be assembled in manual form and shall indicate
organization and responsibility for the control of quality.
4.2.2 Inspection during manufacture. - The contractor shall establish and maintain inspection at appro-
priately located points in the manufacturing process, beginning with the receipt of raw materials and subcon -
tracted parts through final testing and preparation for shipment of completed units, to assure continuous con-
trol of quality of parts, components and assemblies.
4.2.3 The contractor shall provide and maintain gages, instruments and other measuring and testing
equipment and devices necessary to assure that supplies conform to contract requirements. These devices
shall be calibrated against measurement standards or designated measuring equipment at established periods
to assure continued accuracy. The contractor shall prepare and maintain a written schedule for the mainte-
nance and calibration of such equipment based on the type, purpose and degree of usage.
4.2.3.1 All instruments used in preproduction and performance tests shall be calibrated before and after
tests.
15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals