 |
|||
|
Page Title:
Government furnished inspection equipment |
|
||
| ||||||||||
|
|  MIL-P-46029A(MU)
TEST PROCEDURE
REQUIREMENT
MINOR: AQL 2.5%
4.9
3.6
201. Bubbles and Inclusions
4.10
3.6.1
202. Lint
4.4.3 Acceptance and rejection. - Rejected lots shall be screened for
all defective characteristics. Remmoval or correction of defective unit.
and resubmittance of rejected lots shall be in accordance with "Acceptance
and Rejection" as specified in MIL-STD-105.
4.5 Special Sampling.
4.5.1 General.- Three periscopes shall be selected at random by a
Government representative as a special sample from each 100 produced. The
sample sample shall meet the requirements and test procedures in Table II
and shall then meet the requirements end tests in Table I.
TABLE II
REQUIREMENTS TEST PROCEDURES
CHARACTERISTICS
3.2
Fabrication
Applicable drawings -
301.
visual
MIL-F-13926; visual
3.3
302.
General specification
4.5.2 Failure of sample.- Should any one item of a special sampling
fail to meet the specified test requirements, acceptance of the product
shall be suspended by the Government until necessary corrections have been
made by the contractor and resubmitted samples have been approved (see 4.4.3).
4.6 Inspection equipment.- Except as otherwise provided for by the
contract, the contractor shall supply and maintain inspection equipment in
accordance with the applicable requirements of MIL-I-45607.
4.6.1 Government furnished inspection equipment.- Where the contract
provides for Government furnished test equipment, supply and maintenance
of test equipment shall be in accordance with applicable requirements speci-
fied in MIL-I-45607.
4.6.2 Contract furnished inspection equipment.
4.6.2.1 Government design.- All Inspection equipment specified by draw-
ing number in specifications or SQAP's forming a part of the contract shall
be supplied by the contractor in accordance with technical data included in
the technical data package.
4.6.2.2 Contractor design.- The contractor shall design and supply in-
spection equipment compatible with the "Test Methods and Procedures" speci-
fied in 4.6 of this specification and with the component inspection procedures
specified in "Examination" and "Test Facilities" requirements of MIL-F-13926.
Since tolerance of test equipment is normally considered to be within 10 of
the product tolerance for which it Is intended, this inherent error in thc
test equipment design must be considered as part of the prescribed product
tolerance limit. Thus, concept, construction, materials, dimensions and
tolerances used in the design of test equipment shall be so selected and
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals