 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-85018A(AS)
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for Inspection - Unless otherwise specified, the
supplier is responsible for the performance of all test requirements as
specified herein. Except as otherwise specified, the supplier may use his own
facilities or any commercial laboratory acceptable to the Government or the
procuring activity. The Government reserves the right to perform any of the
tests set forth in the specification where such tests are deemed necessary to
assure that supplies and services conform to prescribed requirements.
4.1.1 Classification of Tests - Items covered by this specification shall
be subjected to the following tests to determine compliance with all applicable
requirements.
(1) Preproduction (First Article) Tests
(4.2)
(4.3)
(2) Initial Production Tests
(4.4)
(3) Acceptance Tests
4.2 Preproduction (First Article) Tests - Preproduction tests shall be
conducted by the contractor on equipment representative of the production
equipments to be supplied under the contract. Preproduction tests shall be
accomplished under the approved test procedure of 4.5. The procurement activity
representative shall be advised when tests are to be conducted so that a
Government representative may be designated to witness or supervise the tests
when so desired. Contractors not having adequate facilities to conduct all
required tests shall obtain the services of a commercial testing laboratory
acceptable to the Govenment or the procurement activity.
4.2.1 Preproduction (First Article) Test Data - The contractor shall submit
all data collected in conducting these tests to the procuring activity for
review in accordance with MIL-STD-333 and MIL-STD-1304.
4.2.2 Scope of Tests - Preproduction tests shall include all tests deemed
necessary by the procuring activity to determine that the equipment meets all
requirements of this specification, other applicable specifications and the
contract. Preproduction tests shall include, but not necessarily be limited to
electrical (bench), environmental, electromagnetic interference, reliability
development, and maintainability demonstration tests.
4.2.2.1 Electrical (Bench) Tests - Bench tests shall be conducted to
demonstrate compliance with specified performance parameters. These tests shall
be conducted under standard laboratory conditions. Inspection and examination
to determine compliance with material and workmanship requirements shall be
conducted at this time.
4.2.2.2 Environmental Tests - Environmental tests shall be conducted in the
sequence specified in MIL-T-5422. Environmental tests shall include the
following:
4.2.2.2.1 Temperature/Altitude Test - A temperature/altitude test shall be
performed in accordance with MIL-T-5422 for Class II equipment except that the
short-duration high temperature operational test shall be conducted for one
+95C 30 minute period.
34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals