 |
|||
|
|
|||
| ||||||||||
|
|  MIL-W-52125B
from the closed position. The lid shall remain in the fully open position either by its own weight
or by detent holding devices. Two tension-type fasteners with strikers shall be provided to retain
the lid in the closed position. The fasteners and strikers shall be attached to the toolbox by either
bolts or rivets. A hasp which will acommodate a padlock having a 3/8 inch shackle shall be
provided for locking the toolbox. The toolbox shall be fastened to the unit in a protected position
and the top or the box shall be not more than 4 feet from the ground. A drain hole with rubber
plug shall be provided in the bottom of the toolbox. The toolbox shall be of a size to hold the
emblem and blade (see 3.6), the ground rods (see 3.8.3.1), the jack pads (3.14.7), the tools
specified (see 3.28), and the running light clusters (see 3.14.6.1). The toolbox shall be marked to
indicate the items it contains.
3.30 Items to be furnished with the unit. No shipment of units shall be made unless repair
parts, maintenance tools, and technical publications are included with the shipment or unless
approval for shipment of the units without such items has been received from the contracting
officer.
3.31 Government property.
3.31.1 Government-furnished property. When specified (see 6.2), one dolly, 4-wheel,
15-ton, M354 will be furnished for each unit.
3.31.2 Government-loaned property. The following property in the quantities indicated will
be loaned by the Government (see 6.6):
Item No.
Description
Identification
Qty. f/ea
Unit
1
M-52 - Truck Tractor, 5 Ton,
MIL-T-740
1
6x6
2
M123 - Truck Tractor, 10 Ton,
MIL-T-62012
1
6x6
3
M51 - Truck, Dump, 5 Ton,
MIL-T-740
1
6x6
3.33 Workmanship. All parts components, and assemblies of the unit including castings,
forgings, molded parts, stampings, bearings, seals, machined surfaces, and welded parts shall be
clean and free from sand, dirt, fins, pits, sprues, scale, flux and other harmful extraneous
material. External surfaces shall be free of burrs, sharp edges, and corners, except when sharp
edges and corners are required.
36
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals